Free shipping on orders over $35. See Details

Compare-N-Save

53.8% Glyphosate

Compare-N-Save 53.8% Glyphosate is a post-emergent, systemic herbicide with no soil residual activity. This grass and weed killer is generally non-selective and gives broad-spectrum control of many annual weeds, perennial weeds, woody brush, and trees. It is formulated as a water-soluble liquid. It may be applied through most standard industrial or field-type sprayers after dilution and thorough mixing with water or other carriers according to label directions.

All concentrate. No surfactant.

Where to use:

Around your home Around your farm To control annual and perennial weeds
To control woody brush To control trees In Roundup Ready® crops
In tree, vine, and shrub crops In annual and perennial crops In pastures

When to use:

Annual weeds are easiest to control when they are small. Best control of most perennial weeds is obtained when treatment is made at late growth stages approaching maturity. Refer to the “ANNUAL WEEDS RATE SECTION”, “PERENNIAL WEEDS RATE SECTION” and “WOODY BRUSH AND TREES RATE SECTION” for directions for specific weeds.

Always use the higher labeled rate of this product per acre within the directed range when weed growth is heavy or dense or weeds are growing in an undisturbed (noncultivated) area.

Do not treat weeds under poor growing conditions such as drought, stress, disease, or insect damage, as reduced weed control may result. Reduced results may also occur when treating weeds heavily covered with dust.

How to use:

General Mixing Instructions

This product mixes readily with water. Mix spray solutions of this product as follows:

For hand-held or backpack sprayers (less than or equal to 5 gal. capacity): Add the labeled amount of this product to the spray tank. Fill the spray tank with water and ensure thorough mixing. Alternatively, the labeled amount of this product can be mixed with water in a large container. Fill sprayer with the mixed solution.

For larger tank sprayers (greater than 5 gal. capacity): Fill the mixing or spray tank one-half full with water and start agitation. Add the labeled amount of this product using a circular motion while pouring. Continue filling the spray tank with water and ensure thorough mixing.

Use caution to avoid siphoning back into the carrier source. Use approved anti-back siphoning devices where required by state or local regulations. During mixing and application, foaming of the spray solution may occur. To prevent or minimize foam, avoid the use of mechanical agitators, terminate bypass and return lines at the bottom of the tank and, if needed, use an approved anti-foam or defoaming agent.

Tank Mixing

Prepare the desired volume of spray solution by mixing the amount of this product in water as shown in the following table:

Spray Solution AMOUNT OF PRODUCT
Desired Volume 0.5% 0.75% 1.0% 1.5% 4.0% 8.0%
1 Gallon 0.7 oz. 1.0 oz. 1.3 oz. 2.0 oz. 5.0 oz. 10.0 oz.
25 Gallons 1.0 pt. 1.5 pt. 1.0 qt. 1.5 qt. 4.0 qt. 2.0 gal.
100 Gallons 2.0 qt. 3.0 qt. 1.0 gal 1.5 gal. 4.0 gal. 8.0 gal.

 

2 tablespoons = 1 fluid ounce

Above percentages are on a weight-to-weight basis with water as 8.34 pounds/ gallon.

For use in knapsack sprayers, direct mix the appropriate amount of product with water in a larger container. Fill sprayer with the mixed solution.

Active Ingredients:

Glyphosate, N-(phosphonomethyl)glycine, in the form of its isopropylamine salt* 53.8%
Other Ingredients 46.2%
Total: 100.0%

*Contains 648 grams per liter or 5.4 pounds per U.S. gallon of the active ingredient Glyphosate, in the form of its isopropylamine salt. Equivalent to 480 grams per liter or 4.0 pounds per U.S. gallon of the acid glyphosate.

Product Label:

Disclaimer:

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read the entire label before each use. Use only according to label instructions.

See the complete label for specific use rates and detailed instructions.

Consult the Safety Data Sheet (SDS) for important safety information.

Advice

  1. CHANGES MAY BE IN STORE REGARDING HAY

    During a discussion of the economics of forage-livestock production, the point will usually be made that stored feed (predominately hay) should be a major consideration.  It is a fact that feeding animals during times when pasture forage is not available is typically the greatest expense associated with production of grazing [...]

  2. VARIETY SELECTION IS IMPORTANT

    Once a forage-livestock producer has decided to plant a given forage species, he or she will usually find there are several varieties of which seed is available. So how should a person go about deciding which variety to plant? Advice from friends, neighbors, and respected advisors can be helpful, but [...]

  3. MANAGEMENT APPROACHES CAN BE SYNERGISTIC

    Numerous management factors can have an impact on the economics of beef production, as well as on other livestock enterprises.  Every farm is different, so the relevance of a given issue to a particular farm varies. However, a  management approach that typically is of great economic value often interacts with [...]

  4. Reducing Stored Feed Needs

    The most expensive aspect of raising livestock is providing feed for them. In general, pasture forage is less expensive than hay or other stored feed, including hay. Here is a concise review of the major options for reducing stored feed.   Use Cool Season and Warm Season Forages On some [...]

  5. Your Ragan & Massey Guide: How To Spray RM43

    Whether treating for specific plants or specific areas with RM43, uniform application of herbicide is essential for effective weed control. Varying the rate of application or dilution ratios even slightly can result in either a poor result or unnecessary waste of product—and both are a misuse of time, money, and [...]