Free shipping on orders over $35. See Details

Farmworks

53.8% Glyphosate

Available exclusively at Tractor Supply Co.

FarmWorks 53.8% Glyphosate is a post-emergent, systemic herbicide with no soil residual activity. This grass and weed killer is generally non-selective and gives broad-spectrum control of many annual weeds, perennial weeds, woody brush, and trees. It is formulated as a water-soluble liquid. It may be applied through most standard industrial or field-type sprayers after dilution and thorough mixing with water or other carriers according to label directions.

Weeds around your farm are no problem.

Where to use:

Around your home Around your farm To control annual and perennial weeds
To control woody brush To control trees In Roundup Ready® crops
In tree, vine, and shrub crops In annual and perennial crops In pastures

When to use:

Annual weeds are easiest to control when they are small. Best control of most perennial weeds is obtained when treatment is made at late growth stages approaching maturity. Refer to the “ANNUAL WEEDS RATE SECTION”, “PERENNIAL WEEDS RATE SECTION” and “WOODY BRUSH AND TREES RATE SECTION” for directions for specific weeds.

Always use the higher labeled rate of this product per acre within the directed range when weed growth is heavy or dense or weeds are growing in an undisturbed (noncultivated) area.

Do not treat weeds under poor growing conditions such as drought, stress, disease, or insect damage, as reduced weed control may result. Reduced results may also occur when treating weeds heavily covered with dust.

How to use:

General Mixing Instructions

This product mixes readily with water. Mix spray solutions of this product as follows:

For hand-held or backpack sprayers (less than or equal to 5 gal. capacity): Add the labeled amount of this product to the spray tank. Fill the spray tank with water and ensure thorough mixing. Alternatively, the labeled amount of this product can be mixed with water in a large container. Fill sprayer with the mixed solution.

For larger tank sprayers (greater than 5 gal. capacity): Fill the mixing or spray tank one-half full with water and start agitation. Add the labeled amount of this product using a circular motion while pouring. Continue filling the spray tank with water and ensure thorough mixing.

Use caution to avoid siphoning back into the carrier source. Use approved anti-back siphoning devices where required by state or local regulations. During mixing and application, foaming of the spray solution may occur. To prevent or minimize foam, avoid the use of mechanical agitators, terminate bypass and return lines at the bottom of the tank and, if needed, use an approved anti-foam or defoaming agent.

Tank Mixing

Prepare the desired volume of spray solution by mixing the amount of this product in water as shown in the following table:

Spray Solution AMOUNT OF PRODUCT
Desired Volume 0.5% 0.75% 1.0% 1.5% 4.0% 8.0%
1 Gallon 0.7 oz. 1.0 oz. 1.3 oz. 2.0 oz. 5.0 oz. 10.0 oz.
25 Gallons 1.0 pt. 1.5 pt. 1.0 qt. 1.5 qt. 4.0 qt. 2.0 gal.
100 Gallons 2.0 qt. 3.0 qt. 1.0 gal 1.5 gal. 4.0 gal. 8.0 gal.

 

2 tablespoons = 1 fluid ounce

Above percentages are on a weight-to-weight basis with water as 8.34 pounds/ gallon.

For use in knapsack sprayers, direct mix the appropriate amount of product with water in a larger container. Fill sprayer with the mixed solution.

Active Ingredients:

Glyphosate, N-(phosphonomethyl)glycine, in the form of its isopropylamine salt* 53.8%
Other Ingredients 46.2%
Total: 100.0%

*Contains 648 grams per liter or 5.4 pounds per U.S. gallon of the active ingredient Glyphosate, in the form of its isopropylamine salt. Equivalent to 480 grams per liter or 4.0 pounds per U.S. gallon of the acid glyphosate.

Product Label:

Disclaimer:

It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read the entire label before each use. Use only according to label instructions.

See the complete label for specific use rates and detailed instructions.

Consult the Safety Data Sheet (SDS) for important safety information.

Advice

  1. Feed And Forage Composition

    Things that initially appear to be complex often seem simple once they have been explained and are understood. Perhaps a good example is the composition of livestock feeds and forages. Many of the numerous terms used in describing these components are not commonly used by the general public, which naturally [...]

  2. The Case For Testing Forage

    Only a relatively small percentage of livestock producers regularly test their hay or other stored feed. Some are probably just not aware of, or not well informed about, this service. Unfortunately, many others know about it but apparently don’t consider it important enough to take the time and expend the [...]

  3. Stockpiling Warm Season Grasses

    Less-than-optimum weather conditions, as well as the cost of fertilizer, fuel, and other production inputs are factors that often make it difficult for livestock producers to make a profit.  Providing  nutrition during times when pasture is not available is one of the costliest aspects of producing livestock, so it makes [...]

  4. PASTURES TELL A STORY

    A livestock producer learns a lot about a pasture over time by managing it, but that is not the only way to obtain information about a given field. Often, a great deal can be gained from simple observation, because various plants are more likely to become established and thrive under [...]

  5. KEY HAY STORAGE CONCEPTS

    Providing nutrition when little or no pasture forage is available constitutes the single largest expense associated with most livestock operations. In most cases, hay is the most logical type of stored feed to use. Generally, the less hay required, the greater the cost effectiveness of an operation, and how hay [...]